24-06-06
When welding the end caps on both ends of the motorcycle shock absorber oil tank, resistance seam welding is used to provide shock absorption, reduce thermal deformation and heat-affected zone, and reduce the shunt ratio. Compare the advantages and disadvantages of resistance welding and arc welding when welding shock absorbers. Focus on introducing automatic shock absorber seam welding machine FNM-160, which is a special machine specially designed for shock absorbers.
With the help of an inverter controller, the output frequency of the inverter controller can be adjusted to adapt to different frequency transformers. Compared with conventional high-speed welding machines and intermediate-frequency welding machines, the output frequency is full sine wave, resulting in less spatter in the welding machine; equalization of three-phase energy consumption; less pollution of the power grid; The controller can store 32 welding specifications for users to recall when using; During the welding process, two welding currents can be arbitrarily switched within the same specification; you can count the number of welds; You can connect external industrial control computers, PLCs and other control equipment. to provide remote monitoring, automated control and improve operating efficiency.
Main technical parameters：
Model FNM-160
Input voltage 3P 380+10% 50Hz
Input power 160 KVA
Load continuity factor 50%
Open circuit voltage of the secondary winding 11.6V
Maximum working pressure 7300N
Air source pressure 0.6MPa
Water source pressure 1.5-6.0 kgf/cm3
Water flow 30 l/min
